Error Code 200

Error Code 200

While the SAM Wikipedia indicates:

"200 - requests - Touch OK

Like it said, everything is good don't get greedy!"


The error also indicates that someone else may be streaming on the server and thus not allowing you to connect.

If you were disconnected from the server and an error 200 appears, chances are your disconnection from the server did not register properly. Give it about a  minute and the current connection will time out when SHOUTcast realizes that you are no longer connected to it.

Was this answer helpful?

 Print this Article

Also Read

Error: Disconnecting Gracefully

If you get disconnected from the server, or are unable to connect, and you see message about...

Error Code 11001 - 500 Host Not Found

Taken from Spacial Audio:...

SAM Error: Unable to send data fast enough, clearing cache

To put it mildly, this error indicates that "YOU" cannot send data fast enough to the target...

Error Code 10053

Error 100053 is a generic WinSock error code which can be displayed for a variety of reasons but...

Error Code 10054

You would usually only experience this error message when resetting the stream and attempting to...

Powered by WHMCompleteSolution