Error Code 200

Error Code 200

While the SAM Wikipedia indicates:

"200 - requests - Touch OK

Like it said, everything is good don't get greedy!"


The error also indicates that someone else may be streaming on the server and thus not allowing you to connect.

If you were disconnected from the server and for some reason got disconnected abruptly and an error 200 appears upon reconnect, chances are your disconnection from the server did not register properly, so you might be ghost connected. Give it about a minute and the current connection will time out when SHOUTcast realizes that you are no longer connected to it.

  • 9 Користувачі, які знайшли це корисним
Ця відповідь Вам допомогла?

Схожі статті

Error Code 10054

You would usually only experience this error message when resetting the stream and attempting to...

Error Code 11001 - 500 Host Not Found

Taken from Spacial Audio:...

Error Code 10053

Error 100053 is a generic WinSock error code which can be displayed for a variety of reasons but...

Error Codes 10060 and 10061

10060 - Not connecting to stream host Is the IP address prefixed with http: If so, please...

Common Error Codes (SAM Broadcaster)

The following list shows some of the most common error and information codes you might encounter...